General ice thickness guidelines

For new, clear ice only

2" or less - STAY OFF
4" - Ice fishing or other activities on foot
5" - Snowmobile or ATV
8" - 12" - Car or small pickup
12" - 15" - Medium truck

Note: these guidelines are for new, clear solid ice.
Many factors other than thickness can cause ice to be unsafe.

Click to enlarge:

Download a printable PDF of the Ice Thickness Guidelines card »

Many ice drownings involve children. When your child is near the ice, you should be near your child.
Avoid alcoholic beverages when you’re on the ice. They can make you feel colder and slow down your reaction time in case of an ice emergency.
Carry two large nails to use as ice picks to pull yourself out if you fall through thin ice.
Never drive on the ice at night.
Avoid pressure ridges, and areas with current if you do choose to drive on the ice.
Drive with your windows down and doors partially open to avoid becoming trapped if your car breaks through.

White ice or "snow ice" is only about half as strong as new clear ice. Double the above thickness guidelines when traveling on white ice.

Checking ice thickness

Before heading out on ice:

Contact a local bait shop or lakeside resort to ask about ice conditions.
Check ice thickness once you get there.
Temperature, snow cover, currents, springs and rough fish all affect the relative safety of ice. Ice is seldom the same thickness over a single body of water; it can be two feet thick in one place and one inch thick a few yards away. Check the ice at least every 150 feet.

Check ice thickness using the following:

	Ice chisel An ice chisel is a metal rod with a sharp, flat blade welded onto one end. Drive the chisel into the ice, using a stabbing motion, to create a hole. Next, measure ice thickness with a tape measure.
	Ice auger There are 3 different kinds of augers: hand, electric and gas. Hand augers are low cost, light weight and quiet. Electric augers are also quiet, but use less manual labor than a hand auger. Gas augers drill through ice the fastest, but are heavier, noisier and generally more costly than hand or electric models. After drilling a hole with the ice auger, measure ice thickness with a tape measure.
	Cordless drill Using a cordless drill and a long, five-eighths inch wood auger bit, you can drill through eight inches of ice in less than 30 seconds. Most cordless drills that are at least 7.2 volts will work, but the type of bit is critical. You need a wood auger bit since they have a spiral called a "flute" around the shaft that metal drilling bits don’t. The flutes pull the ice chips out of the hole and help keep it from getting stuck, much in the way a full-sized ice auger works. After drilling a hole, measure ice thickness with a measure tape. Dry the bit and give it a quick spray of silicone lubricant after each use to prevent rust.
	Tape measure Use a tape measure to find ice’s true thickness. Put the tape measure into the hole and hook the bottom edge of ice before taking measurement. You can also use an ice fisherman's ice skimmer with inch markings on the handle in place of the tape measure. Don't judge ice thickness by how easily a chisel or drill breaks the surface. It happens so quickly that it’s easy to overestimate the thickness.
	Additional recommendations Cars, pickups or SUVs should be parked at least 50 feet apart and moved every two hours to prevent sinking. Tip: Make a hole next to the car. If water starts to overflow the top of the hole - the ice is sinking and it’s time to move the vehicle.